Skip to main content

Firmware Version 1.4.1 (Build No. 1.4.1_210511)

Release|2021-06-01

New Features and Improvements​

  1. Upgraded to the 1.1.1i version of OpenSSL.

  2. Intelligent Slave Support

    • Intelligent Slave: A function that enables 1:1 or 1:N matching directly from the Suprema device and transmits the authentication result as OSDP card data to the third-party controller.

  3. Separated event logs of Mobile Access cards and RFID cards.

Bug Fixes​

  1. When calling the BS2_ResetConfigExceptNetInfo API from the BioStar Device SDK, a 'Timeout' error occurred. Affects version: 1.0.0

  2. Card data were output with the wrong BitCount while the device was communicating with a 3rd party controller via OSDP. Affects version: 1.0.0

  3. When using a static IP while DNS server address was configured, a reboot on the device caused communication problems between the server. Affects version: 1.0.0

  4. While the device was communicating with a 3rd party controller via OSDP, the device connected as a slave responded that it supported transparent mode by OSDP_PDCAP even though it did not actually support that mode. Affects version: 1.0.0

  5. If 31 slave devices were connected and one of the devices got disconnected, the master device rebooted. Affects version: 1.0.0

  6. Fingerprint authentication did not work after downgrading from firmware version 1.4.0 to firmware version 1.2.1. Affects version: 1.4.0

  7. It was not able to communicate with a 3rd-party controller via OSDP with the default key before network initialization. (only for devices released with the firmware version 1.4.0 or later) Affects version: 1.4.0

  8. It was able to communicate using default keys after changing the key settings when the device was connected to a 3rd-party device via OSDP. Affects version: 1.3.0

  9. After initializing the slave device's settings, it was not able to connect it to a 3rd-party controller. Affects version: 1.0.0

  10. Secure communication was not available by using the default key after downgrading firmware to version 1.3.1 or below which does not support encryption. Affects version: 1.4.0

Was this page helpful?