Skip to main content

Firmware Version 1.2.1 (Build No. 1.2.1_180523)

Release|2018-06-20

New Features and Improvements​

  1. In a device with an LCD, the user name is displayed on the LCD when authentication is successful even when connected in slave mode.

  2. Support for connecting new devices.

    • BioLite N2(BLN2-PAB), XPass D2(XPD2-GDB, XPD2-GKDB)

Bug Fixes​

  1. Problem that is affected by the schedule set on the device, even though the smart card is set to the bypass card.

  2. Issue where the bypass does not work when authentication with AoC in Wiegand output.

  3. Issue where event logs and real-time logs are not uploaded normally to BioStar 2.

  4. Problem that relay state is not maintained when reconnecting a device connected by RS-485.

  5. Issue in which the door relay status operates as On when the device is reconnected after starting and ending the Schedule Unlock with the door relay device disconnected.

  6. Problem that the time zone is not initialized even if the factory reset is performed while secure communication and data encryption key are in use.

  7. Issue where if the authentication is successful when the device set as door relay is disconnected, the relay will operate according to previous value after reconnection of the device.

  8. Problem that does not respond to the input ground.

  9. Modified to limit kernel downgrade based on the hardware version of the device.

  10. Issue where the device restarts when authenticating with an unregistered fingerprint.

Was this page helpful?